Studio 5000 Programmable Logic Controller Training

Studio 5000 Programmable Logic Controller Training: Programmable Logic Controllers Studio 5000 Logix Designer Basics

Instructor: Darwin Boyd, Ph.D.  
Course Dates: May 19 - May 22, 2025   8:00a.m. - 4:30p.m.
Cost: $1,935
Lunch options provided each day. A parking pass next to the Aeronautics and Engineering Building will be emailed to you before the course begins. 
Contact Dr. Boyd dboyd@kent.edu   330-672-3607 or Lifelong Learning lifelonglearning@kent.edu  330-672-3100

Our Advanced Mechatronics Laboratory is equipped with power supplies, analog and digital IO modules, Tektronix digital oscilloscopes, function generators, Allen-Bradley programmable logic controllers with Logix 5581E processors, Allen-Bradley MicroLogix control systems, Allen-Bradley PanelView Plus 700 HMIs, Allen-Bradley Power Flex 527 VFD motor controllers, IO boxes (light boxes that represent machinery input/output) and Omni 2000 analog/digital trainers.

Computers are equipped with Studio 5000 software to run the programmable logic controllers.

Course Delivery

Registered participants will be provided with online modules up to two weeks prior to the training. In-person, hands-on 32-hour training will consist of approximately 15 laboratory exercises. In addition to lab exercises, a pre-test and post-test are used to measure mastery of objectives. Upon successful completion of the course, participants will receive a Programmable Logic Controllers Studio 5000 Logix Designer Basics certificate of completion.

•  
• Online modules followed by four days in-person training
• Lecture material provided in .pdf format
• Room 029 Aeronautics and Engineering Building, Kent State University, Kent, Ohio